Skip to main content

How to Wall Mount Your VTM

How to wall mount the Mini Wall, Slim Wall, and Mega Wall machines. The Slim Wall and Mega Wall bracket comes attached. The Mini Wall uses a different bracket that ships unattached and is installed first.

The Slim Wall and Mega Wall ship with the mounting bracket already attached to the back of the machine. The Mini Wall uses a different bracket that ships unattached, so it gets attached first. Follow the section for your machine.

Recommended Hardware:

  • Bobibbi 3/16 x 1-1/4" Flat Head Concrete Screw Anchors - Suitable for masonry, block, or brick walls, providing strong and secure anchorage.

  • Hard-to-Find Fastener 1/4" x 2" Fender Washers - Designed to evenly distribute load and prevent pull-through on various surfaces.

  • T.K. Excellent Heavy Duty Zinc Plated Steel Molly Bolt Set - An assortment of sizes for hollow and drywall installations, ensuring a tight, wobble-free setup.

These brands are only examples and Home Depot and any hardware store will have the hardware needed to wall-mount your machine. You can buy our hardware kit by clicking the button below.

VTM Wall-Mounting Hardware Kit

Slim Wall and Mega Wall

The mounting bracket is already attached to the back of the machine. Nothing to assemble before you mount.

  1. Position the Machine: Have one person lift the machine to the desired height against the wall or mounting surface.

  2. Anchor the Top: While the machine is held in place, a second person should anchor the top brackets to the wall using appropriate screws/fasteners.

  3. Anchor the Bottom: Secure the bottom brackets to the wall to ensure the machine is level and stable.

  4. Final Check: Ensure all mounting points are firmly anchored before releasing the weight of the machine.

Mini Wall

The Mini Wall uses a different bracket than the Slim Wall and Mega Wall, and it ships unattached. Attach it to the machine first, then mount.

  1. Locate the Screw Holes: Find the pre-drilled holes on the top and bottom of the machine's rear casing.

  2. Attach Top Brackets: Place a bracket over the top screw hole. Insert a screw through the bracket and into the machine from the outside in.

  3. Attach Bottom Brackets: Repeat this process for the holes located at the bottom rear of the machine.

  4. Position the Machine: Have one person lift the machine to the desired height against the wall or mounting surface.

  5. Anchor the Top: While the machine is held in place, a second person should anchor the top brackets to the wall using appropriate screws/fasteners.

  6. Anchor the Bottom: Secure the bottom brackets to the wall to ensure the machine is level and stable.

  7. Final Check: Ensure all mounting points are firmly anchored before releasing the weight of the machine.

Related Articles
Did this answer your question?