Note that the card reader runs off a separate wireless SIM pre-installed in the card reader
Unbox and Power On the Machine
Remove the keys from the cord after unboxing your wall-mount machine.
Plug the machine into a power outlet.
If the screen doesn’t light up immediately, switch ON the power switch located inside the machine.
Identify the Two Antennas
Inside the box, you’ll find two antennas:
Wi-Fi Antenna — large, circular, and heavier.
Nayax Antenna — smaller antenna pole for the card reader.
Keep both antennas handy for installation.
Install the Wi-Fi Antenna
The antenna is installed at the top of the machine
Screw the Wi-Fi antenna clockwise until it’s snug.
Do not over tighten.
Connect the Machine to Wi-Fi
Hold down the upper right hand corner of the machine to initiate the admin password box
Enter the admin password, using either the default password or the password you have set
Go to 'Equipment Configuration'
Enable the 'Navigation Bar' toggle and submit.
Swipe up on the screen to unlock the interface.
Tap the circle icon, then select Settings → Network & Internet → Wi-Fi.
Select your Wi-Fi network and enter the password.
Wait a few seconds for the connection to complete.