Open the Pedestal Stand:
Use the key that comes with the pedestal.
Unlock and open the pedestal to access the LED light cable.
Locate the LED Connector:
Inside, find a cable with a white connector attached to it.
Open the Vending Machine Panel:
Unscrew and remove the panel where the control board is located (usually behind the front panel).
Prepare the LED Cable:
Use scissors or a blade to remove any wire ties (be careful not to cut the cord).
Feed the Cable Through the Machine:
Find the small hole near the control board.
Feed the LED connector cable through it (use a flashlight if needed).
Connect to the Control Board:
Plug the white LED connector into the appropriate port on the control board.
Reassemble the Machine:
Carefully arrange the cord to avoid blocking the door.
Use tape to secure the cable neatly inside.
Screw the panel back on and close the vending machine door.
Test the Lights:
Confirm that the pedestal light turns on once connected properly.
Pedestal Stand Light Setup Tutorial
Guide to Install Pedestal Light
How to Turn On the Light in Your VapeTM Wall Mount Pedestal Stand
Updated over 10 months ago