Step-by-Step Instructions:
1. Power Down
a. Open the machine.
b. Ensure the machine is turned off.
2. Access the Bottom Tray
a. Locate the bottom tray.
b. Remove 3 screws securing the tray (see reference image 2B).
c. Slide the tray to the left to expose the internal wires (see
reference image).
3. Disconnect Motor Wires
a. Unplug each connector from the motor (see reference image).
b. Remove the tray from the machine.
4. Disassemble Tray and Back Wall
a. Remove the tray holder (see reference image).
b. Remove the 4 screws holding the metal plate (see reference
image).
c. Detach the LED strip from the back wall (see reference image).
d. Remove the 4 screws located on the back wall (see reference
image).
5. Remove the Product Box
a. Gently lift up the product box.
b. Locate and unplug the sensor on the right side of the product
box (see reference image).
c. Locate and unplug the sensor on the left side of the product
box (see reference image).
6. Replace Sensors
a. Remove 2 screws securing the sensor on the right side and
install the new sensor (see reference image).
b. Remove 2 screws securing the sensor on the left side and
install the new sensor (see reference image).
c. Plug the wires back into the new sensors (see reference image).
7. Reassemble Machine
a. Slide the product box back into place.
b. Reinstall the 4 screws in the back of the product box.
c. Affix the LED strip to the back wall using double-sided tape.
d. Reinstall the metal plate with the 4 screws to secure it (see
reference image).
e. Reinstall the tray holder with 2 screws (see reference image).
f. Place the tray back in and plug the wires into the motor by their
number labels.
g. Fasten the hinge using the screws (see reference image).
8. Power Up
a. Turn the machine on to test proper function.